ASSEMBLY INSTRUCTIONS
#2600 TRACK JUDGES STAND
NOTE: All metal seats & footrest are inter-changeable.
- Position frame approximately 43″ apart from the center of cross strap mounting holes.
- Using (4) 3/8″ x 1 3/4″ bolts with nuts, fasten the two long cross straps to the vertical tubes at the rear of each frame. Insert (1) 3/8″ x 3/4″ bolt with nut through the center holes in the cross straps where they intersect each other (Do Not Tighten)
- Using (4) 3/8″ x 1 3/4″ bolts with nuts, fasten the two short cross straps to the vertical tubes at the rear of each frame. Insert (1) 3/8″ x 3/4″ bolt with nut through holes in the cross straps where they intersect each other (Do Not Tighten).
- Place metal seats and footrest on mounting surfaces.
- Next, take each handrail and fasten each handrail with the mounting bracket between the 3rd and 5th metal seats starting from the bottom (No Not Tighten).
- Using (4) 1/4″ x 3/4″ bolts with nuts, fasten the 1″ x 5″ x 48″ backrest plank to handrails (Do Not Tighten).
- Fasten all remaining metal seats and footrest to the frame using 1/4″ x 3/4″ carriage bolts and nuts (Now Tighten All Fasteners). Your Track Judges Stand is now ready for use.
NOTE: A quantity of (4) 1/4″ flat washers may be included for the backrest
as needed.
SKU: 2600II